---

问题描述

通过rv1108.dtsi调整其中dvfs节点下pd_core和pd_ddr对应频率的电压。发现修改后电压并没有改变，一直为11.25v。尝试了将pd_core下的operating-points中的1008000 1150000修改为1008000 1200000，也无作用。将operating-points中频率是留一个，指定电压为1200000。电压依旧为11.25v，那么应该如何修改vdd_core的电压的呢？

---

解决方案：

首先核查SDK的配置，SDK不要开启DVFS变频。
KERNEL下的.config配置如下： # CONFIG_DVFS is not set

如果要修改vdd_core的电压，可以单独加下代码：

diff --git a/drivers/regulator/rk816-regulator.c b/drivers/regulator/rk816-regulator.c
index 0b070b2..1609f60 100644
--- a/drivers/regulator/rk816-regulator.c
+++ b/drivers/regulator/rk816-regulator.c
@@ -766,6 +766,7 @@ static int rk816_regulator_probe(struct platform_device *pdev)struct regulator_config config = {};struct regulator_dev *rk816_rdev;int ret, i;
+    unsigned int sel;if (!pdata || !pdata->chip_name) {dev_err(&pdev->dev, "invalid platform data\n");
@@ -814,6 +815,11 @@ static int rk816_regulator_probe(struct platform_device *pdev)}rk816->rdev[i] = rk816_rdev;
+        if(rk8xx_reg->reg_desc[i].id==RK805_ID_DCDC1
+            ||rk8xx_reg->reg_desc[i].id==RK816_ID_DCDC1){
+           printk("%s>>>>set dcdc1 voltage\n",__func__);
+           rk816_dcdc_set_voltage(rk816->rdev[i],1200000,1200000,&sel);
+        }}

---