1.配置芯片,如果PA9,PA10的UART引脚被占用,会自动进行重映射
2.代码
int main(void)
{uint8_t temp[]="test";/* USER CODE BEGIN 1 *//* USER CODE END 1 *//* MCU Configuration--------------------------------------------------------*//* Reset of all peripherals, Initializes the Flash interface and the Systick. */HAL_Init();/* USER CODE BEGIN Init *//* USER CODE END Init *//* Configure the system clock */SystemClock_Config();/* USER CODE BEGIN SysInit *//* USER CODE END SysInit *//* Initialize all configured peripherals */MX_GPIO_Init();MX_USART1_UART_Init();/* USER CODE BEGIN 2 *//* USER CODE END 2 *//* Infinite loop *//* USER CODE BEGIN WHILE */while (1){HAL_UART_Transmit(&huart1,temp,5,50);//结构体,发送的数据,长度,发送时间/* USER CODE END WHILE *//* USER CODE BEGIN 3 */}/* USER CODE END 3 */
}